The Stepmotor Controller board is designed to control up to 6 step motors and support CAN-FD bus. Its layout and pinout are especially organised and designed for use with a 3D printer.
On board DC step down power supply to provide 5V to ODROID-M1S
6x step motor driver module support
1x CAN-FD bus support
1x ADC channel
2x GPIO inputs
1x MOSFET output
Specifications
Form Factor
Board dimension : 90 (L) x 65 (W) x 16 (H) mm
Power Input
1x terminal block (7.62mm pitch) - * ODROID-M1S will be powered via this terminal.
I/O
6x Step motor connector (Step motor driver module is required.) 1x CAN bus 1x ADC input 1x MOSFET output 2x GPIO input (internal pull up)
![6 Channel Stepper Motor Controller Board for M1S [10010]](https://www.odroid.co.uk/image/cache/catalog/M1S/Stepper Motor/Hero 2-500x500.jpg "6 Channel Stepper Motor Controller Board for M1S [10010]")
![6 Channel Stepper Motor Controller Board for M1S [10010]](https://www.odroid.co.uk/image/cache/catalog/M1S/Stepper Motor/Hero 3-500x500.jpg "6 Channel Stepper Motor Controller Board for M1S [10010]")
