CUBE CASE FOR ODROID H4 

Passionate “old-school” game players from the early 2000’s will be smiling with nostalgia at our homage to the legendary game console released in 2001, with our Odroid-H4 compatible "Cube Case"

The H4 Cube Case can embed an ODROID-H4 board - there are four USB ports on the front panel allowing you to easily connect game controllers or input/output devices, so you can relive the 4 player games of yesteryear with a finer sense of the Nostalgia of bygone gaming years.

There is a power button with a red LED and a function button with a green LED which is configurable. The power button signal need to be connected to the 14-pin IO header of the H4 board through a female-to-female jumper cable.

The green LED can be controlled by a GPIO pin, and the user configurable Function button status can be read by a GPIO pin through the IO header, so they can be accessed with a simple Python script on Linux.

Or, you can use the reset pin on the 14-pin IO header for system reset.

 

Its shape is close to a cube with size of 150x157x110mm. A big handle on the rear side helps you carry the H4 Cube Case around.

• Case Top
• Case Bottom
• Front panel
• USB hub board
• Rear panel
• SATA SSD bracket x 2
• Cushion for SATA SSD x 2
• M3 screw x 4
• Screw for plastic parts x 13
• Rubber feet x 4
• Screwdriver x 1
• 20mm PCB support plastic M3 x 2 (to be used when a Net Card or M.2 2×2 Card is not installed)
• 16mm PCB support metal M3 x 2 (to be used when a Net Card or M.2 2×2 Card is installed)
• 24-pin wire cable (see WARNING below)

 WARNING:

Be careful matching pin 1 of the Cube Case USB hub board and pin 1 of the H4 board header.
The USB ports on the front side do NOT support wake-up in suspend/sleep mode.